Installation anchor
Installation anchor
INSTLANC-UNI-(A2K)
Register now and access our wide range of products
Material: Galvanised steel
Adjustment wheel drive: TX 30
Can be pre-assembled in the workshop
Rapid adjustments possible. The installation anchors are equipped with a gear unit.
Elements can be quickly and conveniently adjusted using a cordless screwdriver.
Premount assembly anchors at bottom and on side.
Position 113 mm dia. hole for mounting assembly anchor a maximum of 30 mm from inner side of frame. Attach sealing tape before fastening assembly anchor on frame profile.
Fold in assembly anchor to transport window
Fold out assembly anchor at construction site prior to installation.
Place window in wall opening.
Adjust window projection (max. 55 mm).
2 windows (105 m²)
Fasten lower assembly anchors.
Place window in water and adjust height at top and bottom according to joint width.
Time-saving adjustability of the windows and adjustment of the position of the assembly anchors with the gear unit using a battery-operated screwdriver and a long TX 30 bit.
Extend side assembly anchor until wall contact is made.
Plumb window.
Fasten lower assembly anchors.
Datasheets(X)
 | |
Internal drive | TX30 |
Material | Steel |
Surface | Zinc plated |
| Load-bearing capacity of construction adhesive | |
| Projection (wall protrusion) | Load-bearing capacity* |
| 35 mm | 600 N |
| 55 mm | 370 N |
| * The values obtained come from testing lab measurements. In practice, deviations may occur. | |